| Agent | |
| Pre-cycle power converters | |
| Set to pre-injection plateau level | |
| Change mode | |
| Increment fill number | |
| Handshake with experiments | |
| Check & monitor power converter settings | SSIS |
| Set TDI settings “parked”, "coarse", "protect" | Settings space? |
| Set collimators “parked” | |
| Set kicker settings | OK |
| Set Injection kickers ON | OK |
| Start auto harmonic decay correction | OK |
| Check and monitor transfer lines | SSIS |
| Beam dumps "ready" | |
| Set BPM gains to pilot, set capture bunch and turns | What sort of settings are these? |
| Check Beam interlock system | BIS |
| Change injection master to LHC | TIMING |
| Agent | |
| Pre-cycle power converters | |
| Set to pre-injection plateau level | |
| ramp to injection level | |
| Change mode | |
| Increment fill number | |
| Handshake with experiments | |
| Check & monitor power converter settings | SSIS |
| Set TDI settings “parked”, "coarse", "protect" | Settings space? |
| Set collimators “parked” | |
| Set kicker settings | OK |
| Set Injection kickers ON | OK |
| Start auto harmonic decay correction | OK |
| Check and monitor transfer lines | SSIS |
| Beam dumps "ready" | |
| Set BPM gains to pilot, set capture bunch and turns | What sort of settings are these? |
| Check Beam interlock system | BIS |
| Change injection master to LHC | TIMING |
| DR | LSA | Other Agent | ||
| Drive | X | Load and/or check injection timing table | CBCM | |
| Drive | X | Make request to CBCM with ring, bucket number, PS user (intensity) and number of PS batches | ||
| Timing | X | Injection into LHC - injection kickers, BI receive pre-pulses. BST sends out acquisition event for BPMs, BLMs as required. | Acquire [BCT, BPMs, BLMs, SRM] | |
| On event | LFB,TFB,RF: Batch dependent settings triggered by timing events. |
|||
| After kick | X | Acquire kick waveform | OASIS |
Followed by post-injection checks - did acquisition, concentration, publish, timestamping etc. work? Repeat as necessary.
| DR | |||
| Manual | Check first turn, energy offset, beam loss, intensity, emittance, RF response, longitudinal emittance | ||
| Automatic | X | Check BLMs, trajectory in transfer line | |
| Manual | X | Measure tune, orbit, chromaticity | |
| Sequencer | Configure and start global orbit feedback | ||
| Automatic | Monitor lifetime, beam losses | ||
| Automatic | Monitor harmonic correction | ||
| Sequencer | TDI,TCDQ to coarse | ||
| Sequencer | X | Collimators to coarse | |
| Sequencer | X | Change mode |
| DR | |||
| Incorporate trims | |||